The RTT overflow callback is not available on all RTT implementations.
This means it is either a no-op or `rtt_set_overflow_cb()` is a no-op
or it will overwrite the alarm set with `rtt_set_alarm()`.
This adds a feature to indicate that proper overflow reporting is available.
This allows to use the sam0 RTT together with the rtt_rtc module.
The idea is to use RTT as a monotonic counter, but still keep track
of the time with the virtual RTC module.
In I2C, clock stretching occurs when the controller stops driving SCL
down but the peripheral continues to drive SCL down until the value of
SDA that is expected to be set by the peripheral is ready. This allows a
peripheral to communicate at a high speed but introduce a delay in the
response (like an ACK or read) in some specific situations. Not all I2C
peripherals require I2C stretching, and in many cases SCL is only an
input to these peripherals.
Clock stretching is the only situation where a peripheral may drive down
SCL, which technically makes SCL an open-drain with a pull-up like SDA.
However, if clock stretching is not needed, SCL can be configured as an
output removing the need for a pull-up and specially, allowing to use
as SCL GPIO pins that otherwise have a pull-down connected. In
particular, GPIO15 in the ESP8266 requires an external pull-down during
boot for the ESP8266 to boot from the flash.
This patch allows a board to define `I2C_CLOCK_STRETCH` to 0 to disable
clock stretching and allowing to use GPIO15 as SCL.
If we configure TAMPCTRL early, GPIO events will set bits in the
TAMPCTRL register.
That means that after a wake-up, we can't tell if the bit was set
because it was the wake-up source or if it was already set by a
run-time GPIO event.
The extra `)` was a typo from the commit that changes the makefile
inline "if" to a multi-line "if" block.
Tested with `USEMODULE="esp_gdbstub" make BOARD=esp8266-esp-12x -C tests/lwip`
The current xmega don't have a way to disable peripherals that are
not in used. Add peripheral management to allow enable only the mcu
blocks that will be used by application. This saves power on active
and sleep modes. By default, at clock initialization, all peripherals
are now disabled and each drive must activate at initialization phase.
The periph_timer and periph_uart were updated with this new feature.
Signed-off-by: Gerson Fernando Budke <nandojve@gmail.com>
