The EDBG debugger on the `samr21-xpro` contains a unique 64 bit address
intended to be used as a MAC address for the internal radio.
This adds a driver to read that EUI-64 from the debugger, it should match
with the MAC address printed on the label on the board.
Implemented a check in coap_parse() to verify if TKL value is within valid range as specified by RFC7252. The token length must be within 0-8 range, any other value should be considered as invalid and the packet should produce message format error.
A test case was added to tests-nanocoap.c to verify correct behavior in case of TKL in range and out of range.
Update sys/net/application_layer/nanocoap/nanocoap.c
Prefixed debug message with module name and abbreviations expanded.
Co-authored-by: Martine Lenders <mail@martine-lenders.eu>
Update sys/net/application_layer/nanocoap/nanocoap.c
Prefixed debug message with module name and abbreviations expanded.
Co-authored-by: Martine Lenders <mail@martine-lenders.eu>
Expose the option to use default cs pins defined as DEFAULT_SPI_CS_PORT and DEFAULT_SPI_CS_PIN.
This is used if a wiring environment is already defined.
CFLAGS can be used to define the CS pin from the environment provided allowing easier automation of tests.
This commit extends the periph_spi benchmark with timing statistics for
the thread runtime, counting only the time the thread initiating the SPI
request is busy with the SPI transfer. This is useful to measure timings
on SPI transfers when DMA and other async mechanisms are used to
transfer the bytes
Check that single and double quotes work, along with backslash escaping
and that malformed strings are rejected.
Right now the test is failing. The next commit will replace the tokenizer
with one that works correctly.
Co-authored-by: Juan Carrano <j.carrano@fu-berlin.de>
The ATmega PWM implementation only supports a maximum resolution of 256.
Thus when running `osci` with `OSC_STEPS` = 1000 an assertion will fail and
the test crashes, even though the PWM peripheral works perfectly fine.
Limit OSC_STEPS to 256 so it works on all platforms.
The LED flashing doesn't look any more coarse.
- Drop duplicated `cpu.c` and `cpu_conf.h`: Those are already provided by
`cpu/atmega_common`.
- The higher values for default stack size of `cpu_conf.h` in
`cpu/atmega_common` results in three tests no longer fitting the available RAM
==> Updated the Makefile.ci to skip linking of those tests for the Arduino
Leonardo
