The PWM decodeer, in LOAD=Single mode, loads data in groups of 4
half-words. Previously, if any channel was not connected to a pin (a
connection that's immaterial to the loader), a smaller number would be
given resulting in the decoder not loading anything at all.
See-Also: https://infocenter.nordicsemi.com/pdf/nRF52840_PS_v1.1.pdf#page=256
Once PWM is running, the active PWM module overrides the PIN_CNF state;
only when PWM is stopped the pin returns into its PIN_CNF state (which,
then, the board may set to whatever idle means there).
(Moreover, the code there only worked for P0 registers, not eg. the
P1.09 of the nrf52840dongle's RGB LED).
Native CAN device was not properly ported to periph_can interface.
This commit fixes this by renaming all needed structures and files so
auto_init_can can initialize the native device. FEATURES_PROVIDED is
also updated for native.
- Enforced that ISR_STACKSIZE is indeed a multiple of 4
- With this enforced, every cast that triggers a -Wcast-align warning is now
a false positives, so those were silenced by (intermediately) casting to
`uintptr_t`.
This didn't change binaries for me. Either the linker script already took care
of it through the section names of the stacks, or I just was lucky. If I was
just luck, this fixes a bug. If not, it makes the hidden alignment explicit in
the C code, so that code review is easier.
> Allows flahsing CCFG configuration using Kconfig,
formely "make menuconfig".
> Supports cc26x0, cc26x2_cc13x2.
> Can be used to enable bootloader backdoor, to use
cc2538-bsl flashing script.
> Not all options are in Kconfig, most important ones,
others can be added in further commits.
> On cc13xx targets the VDDR high option can be enabled
using Kconfig.
> With this, RIOT can flash blank chips and the firmware
will run just fine.
Signed-off-by: Jean Pierre Dudey <me@jeandudey.tech>
This add a custom ldscript for cc26xx_cc13xx CPUs,
which allows linking CCFG configuration, usage of GPRAM,
etc.
Signed-off-by: Jean Pierre Dudey <me@jeandudey.tech>
The RTC on the fe310 is emulated using the RTT.
This only works if the RTT frequency is 1 Hz, so default to that
value in case `periph_rtc` is selected.
Use RTC helper functions instead of libc functions.
This gives us y2038 safety by the extended epoch and saves
a good chunk of memory:
picolibc mktime():
text data bss dec hex filename
15048 520 2504 18072 4698 tests/periph_rtc/bin/hifive1/tests_periph_rtc.elf
rtc_mktime():
text data bss dec hex filename
7632 40 2452 10124 278c tests/periph_rtc/bin/hifive1/tests_periph_rtc.elf
