Not all MCUs ≥ Cortex-M3 provide the Bit-Banding feature.
It is up to the manufacturer to implement it.
Instead, rely on the CPU_HAS_BITBAND being set in `periph_cpu.h`.
A race condition is present where an IRQ is serviced between the
priority increase of the PENDSV and the sleep. When the IRQ
is serviced before the WFI sleep, the core will sleep until the next
IRQ and the thread activated by the IRQ will not be scheduled until
a new IRQ triggers.
This commit wraps an IRQ disable and restore around the priority
modification and sleep to prevent interrupts from being serviced until
the WFI call returns.
- Make use of the fact that gpio_init_af() does not need prior call to
gpio_init() for all STM32 families anymore and drop call to gpio_init()
- Initialize the UART periph first, before initializing the pins
- While uninitialized, the UART periph will send signal LOW to TXD. This
results in a start bit being picked up by the other side.
- Instead, we do not connect the UART periph to the pins until it is
initialized, so that the TXD level will already be HIGH when the pins
are attached.
- This results in no more garbage being send during initialization
- Do not set an intermediate mode, prepare correct mode settings in a temporary
variable
- Consistently enabled the GPIO periph in gpio_init_af()
- Previously, STM32 F1 did not require a separate call to gpio_init() prior
to a call of gpio_init_af(), but other STM32 families did
- Now, gpio_init_af() can be used without gpio_init() consistently
- STM32 F1: Do not touch ODR for non input pins
- For input pins, this enables / disabled pull up resistors. For outputs,
this register should remain untouched (according to API doc)
- Add libstdcpp feature to indicate a platform is providing a libstdc++
implementation ready for use
- The existing cpp feature now only indicates a working C++ toolchain without
libstdc++. (E.g. still useful for the Arduino compatibility layer.)
- Added libstdcpp as required feature were needed
- Added some documentation on C++ on RIOT
The `ldr r1, =sched_active_thread` instruction couldn't be assembled with
LTO, as the no immediate offset could be found to construct the address of
`sched_active_thread`. This commit instructs the assembler to generate a
literate pool which can be used to construct the address. While this issue
was only triggered during LTO, it theoretically could also pop up without LTO
due to unrelated changes. Thus, it is a good idea to create the literate pool
even without LTO enabled.
cpu/stm32/qdec: test if callback pointer is set
Callback pointer is not tested and could result in a hard fault
if the pointer is NULL.
Thus only activate interrupt if a callback provided.
Signed-off-by: Gilles DOFFE <g.doffe@gmail.com>
The EFM32 uses the provided _SILICON_LABS_32B_SERIES_0 and
_SILICON_LABS_32B_SERIES_1 definitions to enable or disable certain
code. With the introduction of new MCUs, there is also the
_SILICON_LABS_32B_SERIES_2 definition.
This PR ensures that the defines are explicit, and that #else
statements don't target the wrong series.
Other archs use `_sheap` and `_eheap` to mark the start and end of
the heap.
fe310 uses `_heap_start` and `_heap_end`, so platform independent
code that wants to make use of this will needlessly fail.
For compatibility with common code, name them the same on fe310.
>All of them are features of each ESP SoC and have not to be configured by the
board definition.
Signed-off-by: Jean Pierre Dudey <jeandudey@hotmail.com>
Co-authored-by: Gunar Schorcht <gunar@schorcht.net>
