2.2 KiB
@defgroup boards_nucleo-c031c6 STM32 Nucleo-C031C6 @ingroup boards_common_nucleo64 @brief Support for the STM32 Nucleo-C031C6
Overview
The Nucleo-C031C6 is a board from ST's Nucleo family supporting a ARM Cortex-M0+ STM32C031C6 microcontroller with 12KiB of RAM and 32KiB of Flash.
Pinout
@image html pinouts/nucleo-c031c6.svg "Pinout for the Nucleo-C031C6 (from STM user manual UM2953, https://www.st.com/resource/en/user_manual/um2953-stm32-nucleo64-board-mb1717-stmicroelectronics.pdf, page 19)" width=50%
MCU
| MCU | STM32C031C6 |
|---|---|
| Family | ARM Cortex-M0+ |
| Vendor | ST Microelectronics |
| RAM | 12KiB |
| Flash | 32KiB |
| Frequency | up to 48MHz |
| FPU | no |
| Timers | 12 (2x watchdog, 1 SysTick, 5x 16-bit) |
| ADCs | 1x 12-bit (up to 19 channels) |
| UARTs | 2 |
| SPIs | 1 |
| I2Cs | 1 |
| RTC | 1 |
| Vcc | 2.0V - 3.6V |
| Datasheet | Datasheet |
| Reference Manual | Reference Manual |
| Programming Manual | Programming Manual |
| Board Manual | Board Manual |
Flashing the Board Using ST-LINK Removable Media
On-board ST-LINK programmer provides via composite USB device removable media. Copying the HEX file causes reprogramming of the board. This task could be performed manually; however, the cpy2remed (copy to removable media) PROGRAMMER script does this automatically. To program board in this manner, use the command:
make BOARD=nucleo-c031c6 PROGRAMMER=cpy2remed flash
@note This PROGRAMMER was tested using ST-LINK firmware 2.37.26. Firmware updates could be found on this STM webpage.