2.2 KiB
@defgroup boards_nucleo-g071rb STM32 Nucleo-G071RB @ingroup boards_common_nucleo64 @brief Support for the STM32 Nucleo-G071RB
Overview
The Nucleo-G071RB is a board from ST's Nucleo family supporting a ARM Cortex-M0+ STM32G071RB microcontroller with 36KiB of RAM and 128KiB of Flash.
Pinout
@image html pinouts/nucleo-g070rb-and-g071rb.svg "Pinout for the Nucleo-G071RG (from STM user manual UM2324, https://www.st.com/resource/en/user_manual/um2324-stm32-nucleo64-boards-mb1360-stmicroelectronics.pdf, page 34)" width=50%
MCU
| MCU | STM32G071RB |
|---|---|
| Family | ARM Cortex-M0+ |
| Vendor | ST Microelectronics |
| RAM | 36KiB |
| Flash | 128KiB |
| Frequency | up to 64 MHz |
| Timers | 14 (2x watchdog, 1 SysTick, 10x 16-bit and 1 32-bit) |
| ADCs | 1x 12 bit (up to 16 channels) |
| UARTs | 5 (four USARTs and one Low-Power UART) |
| I2Cs | 2 |
| SPIs | 2 |
| RTC | 1 |
| Datasheet | Datasheet |
| Reference Manual | Reference Manual |
| Programming Manual | Programming Manual |
| Board Manual | Board Manual |
Flashing the Board Using ST-LINK Removable Media
On-board ST-LINK programmer provides via composite USB device removable media. Copying the HEX file causes reprogramming of the board. This task could be performed manually; however, the cpy2remed (copy to removable media) PROGRAMMER script does this automatically. To program board in this manner, use the command:
make BOARD=nucleo-g071rb PROGRAMMER=cpy2remed flash
@note This PROGRAMMER was tested using ST-LINK firmware 2.37.26. Firmware updates could be found on this STM webpage.