RIOT/boards/stm32f469i-disco/doc.md

@defgroup boards_stm32f469i-disco STM32F469I-DISCO @ingroup boards @brief Support for the STM32F469I-DISCO board

Table of Contents:

1. Overview
2. Hardware
3. Connectors and Pinout
4. Buttons, LEDS and other devices
5. Working with this Dev-Kit.

Overview

The STM32F469I Discovery kit is a complete development platform for powered by ARM Cortex-M4 core-based STM32F469NIH6 MCU. The MCU presents a large list of peripherals available, but specifically this development board exposes:

Hardware

MCU	STM32F469Ixx
Family	ARM Cortex-M4F
Vendor	ST Microelectronics
RAM	384+4 KiB
Flash	2 MiB
Frequency	180 MHz
FPU	Yes
Timers	12
ADCs	3 12-bit (16 channels each)
DACs	2 12-bit
USARTs	4
UARTs	4
SPIs	6
I2Cs	3
I2Ss	2
CANs	2
USBs	1 Full Speed
Ethernet MAC	Yes
RNG	Yes
SDRAM	Yes (16 MByte)
Vcc	1.7V - 3.6V
Datasheet	MCU Datasheet (pdf)
Reference Manual	Dev-Kit Reference Manual (pdf)

Connectors and Pinout

• 1 USB Mini-B used by the On-board ST-LINK debugger (Ref.CN1)
• 1 USB Micro-AB Full speed (Ref. CN13)
• Arduino(R) Uno expansion connectors (Refs. CN5/6/7/8)
• microSD(tm) card receptacle.
• Audio 3.5 mm stereo jack

Through 2 connector we have available:

CN11

• I2C1
• Reset

Also provides power pins, 3V3 and GND

CN12

This extension connector gives access to:

• CAN2
• USART6 (Tx, Rx)
• I2S2
• SPI1
• 7 timers channels
• Speaker output (1W)

Also provides some system signals and power.

Important! note than some pins are shared between peripherals.

Buttons, LEDS and other devices

• 1 Button for reset
• 1 User button
• 4 LEDs
• 3 Digital microphones
• 1 LCD Color 4 inches

Working with this Dev-Kit

To start the gcc-arm-embedded toolchain have to be installed, we can follow the usual process here.

Flashing the device

Flashing the Board using OpenOCD

The start install OpenOCD, also we can follow the usual process here

Once everything is installed and ready to work just connect the board through the USB Mini-B connector try to compile and flash some code, type:

make flash BOARD=stm32f469i-disco

Flashing the Board Using ST-LINK Removable Media

On-board ST-LINK programmer provides via composite USB device removable media. Copying the HEX file causes reprogramming of the board. This task could be performed manually; however, the cpy2remed (copy to removable media) PROGRAMMER script does this automatically. To program board in this manner, use the command:

make BOARD=stm32f469i-disco PROGRAMMER=cpy2remed flash

@note This PROGRAMMER was tested using ST-LINK firmware 2.37.26. Firmware update s could be found on [this STM webpage](https://www.st.com/en/development-tools/sts w-link007.html).