2.4 KiB
@defgroup boards_nucleo-l496zg STM32 Nucleo-L496ZG @ingroup boards_common_nucleo144 @brief Support for the STM32 Nucleo-l496zg
Overview
The Nucleo-L496ZG is a board from ST's Nucleo family supporting ARM Cortex-M4 STM32L496ZG ultra-low-pawer microcontroller with 320KiB of RAM and 1 MiB of Flash.
Pinout
@image html pinouts/nucleo-l496zg.svg "Pinout for the Nucleo-L496ZG (from STM user manual, UM2179, https://www.st.com/resource/en/user_manual/um2179-stm32-nucleo144-boards-mb1312-stmicroelectronics.pdf, page 31)" width=55%
MCU
| MCU | STM32L496ZG |
|---|---|
| Family | ARM Cortex-M4F |
| Vendor | ST Microelectronics |
| RAM | 320KiB |
| Flash | 1MiB |
| Frequency | up to 80MHz |
| FPU | yes |
| Timers | 16 (2x watchdog, 1 SysTick, 11x 16-bit, 2x 32-bit) |
| ADCs | 3x 12-bit (24 channels |
| UARTs | 6 (5x UARTs and one Low-Power UART) |
| SPIs | 3 |
| I2Cs | 4 |
| RTC | 1 |
| CAN | 2 |
| Datasheet | Datasheet |
| Reference Manual | Reference Manual |
| Programming Manual | Programming Manual |
| Board Manual | Board Manual |
Flashing the Board Using ST-LINK Removable Media
On-board ST-LINK programmer provides via composite USB device removable media. Copying the HEX file causes reprogramming of the board. This task could be performed manually; however, the cpy2remed (copy to removable media) PROGRAMMER script does this automatically. To program board in this manner, use the command:
make BOARD=nucleo-l496zg PROGRAMMER=cpy2remed flash
@note This PROGRAMMER was tested using ST-LINK firmware 2.37.26. Firmware updates can be found on [this STM webpage](https://www.st.com/en/development-tools/stsw-link007.html